Blind Nailing Flooring

Drill pilot holes approximately.

Blind nailing flooring. Blind nail glue. In olden times blind nailing was done with a hammer to start the nail then as a woodworker got close to the wood a nailset was used with the hammer to countersink the. Support see jane drill by. Drill pilot holes along the tongue side of the board using an appropriately sized drill bit for the nails.

Blind nailing is setting a nail into the hardwood flooring board at a 45 degree angle just above the tongue of the board and driven down into the joist or subfloor surface. For stubborn boards there are several options. For tongue and groove flooring drive a nail at a 45 degree angle through the tongue then conceal it by engaging the groove of the next board. Flooring nails have special qualities that make them suitable for the job.

Blind nail the board into place. Depending on the width of the flooring it may be necessary to do this for the first few rows prior to using a pneumatic stapler nailer. Types of nails for laying hardwood floor. The process involves driving a series of nails into the tongue of a.

If you are installing your floor to a standard plywood subfloor then the blind nail and glue method is the best installation for you. When using a flooring nailer the nose of the tool is set down on the top inside corner of the board s tongue while the nail is driven at an angle through the flooring material and into the subfloor. The process of blind nailing. When nailing the final courses do so by blind nailing or nailing into the groove at a 45 degree angle.

Set the bit in the corner formed by the tongue and edge of the board angled at 45 degrees. Fill nailed areas with appropriate colored wood filler to match the flooring. The humble nail has a long history of craftsmanship behind every bag or box. Blind nail at a 45 angle through the tongue 1 2 from the end joints and every 6 in between along the length of the starter boards predrill holes to make this easier.

At one point it will be necessary to top nail the last few rows. Blind nailing is a method of concealing a nail using the adjacent installed board. Leah demonstrates how the blind nailing technique for attaching tongue and groove wood boards to a floor wall or other surface. You can use this method for pine hardwood or reclaimed flooring if your floor was made with a tongue and groove edge as seen below.

Be sure to countersink the nail drive it slightly below the surface of the wood to prevent interference in the.